Archives

Append Mode

      Comments Off on Append Mode

Getting Started This article will cover how to use the Append Mode with EdgeWise piping. There are some circumstances where point cloud data may not be good enough for extraction, or a complicated S-curve may exist in the project. In these scenarios a common workaround is to use the Append… Read more »

Reducing Elbow Workaround

      Comments Off on Reducing Elbow Workaround

Getting Started This article will cover a workaround for reducing elbows for piping and round ducting within EdgeWise. Reducing Elbows DO NOT transfer over to any deliverable, however, there is a workaround that can be representative of the reducing elbow geometry. Workaround While reducing elbows fail to export out to… Read more »