Archives

Append Mode

      Comments Off on Append Mode

Getting Started This article will cover how to use the Append Mode with EdgeWise piping. There are some circumstances where point cloud data may not be good enough for extraction. Or a complicated S-curve may exist in the project. In these scenarios a common workaround is to use the Append… Read more »

This tool may only be used to connect non-black pipes error

      Comments Off on This tool may only be used to connect non-black pipes error

Getting Started This tool may only be used to connect non-black pipes error. This error appears when you attempt to use the Connect tool between connections instead of pipes. This could be an elbow, straight connection, reducer, or Tee connection. You cannot connect these connections to each other. These connections… Read more »

Reducing Elbow Workaround

      Comments Off on Reducing Elbow Workaround

Getting Started This article will cover a workaround for reducing elbows for piping and round ducting within EdgeWise. Reducing Elbows DO NOT transfer over to any deliverable. However, there is a workaround that can be representative of the reducing elbow geometry. Workaround While reducing elbows fail to transfer over to… Read more »

Semi-Automatic Extraction & Connection

      Comments Off on Semi-Automatic Extraction & Connection

Getting Started This guide will walk you through the Semi-Automated Extraction and Connection portions of the piping workflow. To begin this workflow, ensure you have a point database model, and piping model for your project already created, QA’ed, Cleaned and opened. The Semi-Automated Extraction and Connection tools are designed to… Read more »

Alignment and Connection

      Comments Off on Alignment and Connection

Getting Started The ducting module inside of EdgeWise allows you to extract rectangular ducting from the point database. This guide will walk you through the different Alignment and Connection portions of the workflow. At this stage in the workflow you should have already used the Semi-Automated Extraction and QA tools…. Read more »