Archives

Volume Tool

      Comments Off on Volume Tool

Getting Started This article will go over how to use the Volume tool. The Volume tool calculates the amount of material that is needed to add or remove from a surface to match a specific reference elevation. This tool is located in the Builder Toolbar, under Surfaces: Using the Volume… Read more »

ASTM 1155 Floor Flatness

      Comments Off on ASTM 1155 Floor Flatness

Getting Started This article will cover how to use the Floor Flatness tool within the Inspector Toolbar. The Floor Flatness tool allows you to create ASTM 1155 Floor Flatness/Floor Levelness runs and reports. To adjust settings for this function, refer to this article. Create a Debris Filter The Debris Filter… Read more »