Archives

Builder – Settings

      Comments Off on Builder – Settings

Getting Started This article will cover the Settings found within the Builder Toolbar. These settings will adjust various parameters for the surfaces and analysis functions. For more information on these tools and functions, start with the Builder Toolbar Overview article. The Builder Toolbar Settings button is located in the Builder… Read more »

Wall Heatmap

      Comments Off on Wall Heatmap

Getting Started This article will cover how to create a Wall Heatmap. The Wall Heatmap will generate a heat map of a sectioned wall, similar to how normal heat maps work for slabs. If you are looking for heat map information for slabs, refer to this article. Workflow You can… Read more »

Builder Toolbar Overview

      Comments Off on Builder Toolbar Overview

Getting Started This article will provide a brief overview of the various functionality found within the Builder Toolbar. Each section will include a hyperlink to an article that dives into more detail. The Builder Toolbar provides tools that create heat maps, contour maps, and other similar items which are covered… Read more »

Monitor Changes

      Comments Off on Monitor Changes

Getting Started This article will cover how to use the monitor changes tool with regards to Grid of Points and Beam Camber analysis’. Monitor changes allows a user to compare the results of their elevation points from grid of points or their deflection measurements from a Beam Camber analysis. Workflow… Read more »

Beam Camber Analysis

      Comments Off on Beam Camber Analysis

Getting Started This article will cover the Beam Camber Analysis tool found under the Analysis button in the Builder Toolbar. The Beam Camber Analysis tool will analyze the deflection of a beam under structural loading. It is important that section off your pointcloud in a way so that you isolate… Read more »

Wet Concrete

      Comments Off on Wet Concrete

Getting Started This article will cover the Wet Concrete tool found in the Surfaces menu in the Builder Toolbar. The wet concrete tool is a combination of the Debris Filter and Heat map tools. Wet Concrete To use this tool first open the builder tool bar, then select surfaces. Next,… Read more »

Points

      Comments Off on Points

Getting Started This article will cover the Points tool found under Analysis in the Builder Toolbar. You can use the Points tool to spot check elevation points in your pointcloud. You can find this tool under the Analysis button in the Builder Toolbar. To use this tool, select the points… Read more »

Grid of Points

      Comments Off on Grid of Points

Getting Started This article will cover how to make a Grid of Points. A Grid of points is a section of elevation points that are shown over a defined area of your pointcloud. This tool allows you to define a the width, depth, and spacing to then which Rithm will… Read more »

Heat Map

      Comments Off on Heat Map

Getting Started This article will cover the creation of a heat map. This offers a powerful tool by coloring the floor points to show varying high and low spots. It is recommended to apply a debris filter before starting this workflow. There are two methods for this type of map… Read more »

Contour Map

      Comments Off on Contour Map

Getting Started This article will cover how to create a contour map. The overview of contour map creation is defining an area to be analyzed, set your settings, and then exporting out your result. We recommend applying a debris filter before moving onto map creation. Creation There are two methods… Read more »